SKU 95497 For technical questions, please call 1-800-444-3353 PAGE 16
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE
OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER
AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL
PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
TROUBLESHOOTING
Problem Possible
Cause
Possible
Solution
Guide Bar and Saw Chain running hot
and smoking.
1. Chain tension too tight.
2. Chain Oil Tank empty.
1. Re-adjust Chain Tensioning Screw
to lesson tension on Chain.
2. Refill Chain Oil Tank.
Engine runs, but Saw Chain is not
rotating.
1. Chain tension too tight.
2. Damaged Guide Bar and/or Chain.
3. Worn clutch.
1. Re-adjust Chain Tensioning Screw
to lesson tension on Chain.
2. Have a qualified service technician
repair or replace Guide Bar and/or
Chain.
3. Replace clutch.
Chain rotates while Engine is at idle.
1. Engine idle speed set too high.
1. Have a qualified service technician
reset Carburetor idle adjustment
screws to lower idle (RPM) speed.
Stop Switch does not turn off Engine.
1. Defective Stop Switch.
1. Immediately remove Spark Plug
Cap from Spark Plug to stop Engine.
Discontinue using Chain Saw until a
qualified service technician can repair
or replace Stop Switch.
