NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagram on page 15.
SKU 03068
PAGE 11
MOUNTING INSTRUCTIONS
1.
The Compressor Motor features
four slotted holes in its Base (part #8) by which
to mount the Motor on a mounting surface. (See Assy. Diagram.)
2.
Make sure there are four holes in the mounting surface that will align with the
four slotted holes in the Base of the Compressor Motor.
3.
When connecting a fan belt from the air compressor to the Shaft (part #5) of the
Compressor Motor, make sure the
pulleys (not included) of the air compressor
and Compressor Motor are
properly aligned or Motor life will be significantly
shortened. To align the pulleys, simply slide the Compressor Motor foward or
backward on the mounting surface. Once the pulleys are aligned, use four bolts,
four flat washers, four lock washers, and four nuts (not included) to secure the
Compressor Motor to the mounting surface.
WIRING INSTRUCTIONS
1.
The Compressor Motor is designed to operate on either 120 VAC or 230 VAC
single phase circuits. Additionally, the Motor may be wired to either run in a
clockwise or counterclockwise rotation. Proper wiring ensures maximum effi-
ciency and safe operation.
2.
With a phillips screwdriver, remove the Screw (part #31) and remove the Switch
Board Cover (part #30) to expose the
six number/color coded wires in the
Compressor Motor. (See Figure E.)
SCREW (#31)
SWITCH BOARD COVER (#30)
SHAFT
(#5)
OVERLOAD SWITCH
BUTTON COVER (#12)
FIGURE E
Brought To You By Augusta Flint
