10
Red Hawk
Safety and operating instructions
9800 0658 93
Additional safety
instructions
Machines and accessories must only be used for
their intended purpose.
Only qualified and trained persons may operate
or maintain the machine.
Keep your hand away from the start and stop
device until work is to begin.
Learn how the machine is switched off in the
event of an emergency.
The machine should be operated at reduced
power when drilling is started.
Release the start and stop device in case of
interruption of the energy supply.
Always inspect the equipment prior to use.
Do not use equipment if you suspect that it
could be damaged.
Check the working tools for wear or damage
at regular intervals. Do not use worn out or
damaged working tools.
Always use your common sense and good
judgment.
Do not use the machine when you are tired
or under the influence of drugs, alcohol or
anything else that may affect your vision,
reactions or judgement.
Participate in safety and training courses.
Never strike or abuse any equipment.
Keep the machine and tools in a safe and locked
place out of the reach of children.
Make sure that the all attached and related
equipment is properly maintained.
Signs and stickers that are important for your
safety and the care of the machine are included
with every machine. New signs and stickers can
be ordered using the spare parts list.
Protective equipment
Always use approved personal protective
equipment. Operators and other persons in the
work area must wear protective equipment,
including at a minimum:
Protective helmet
Hearing protection
Impact resistant eye protection with side
protection
Respiratory protection when appropriate
Protective gloves
Protective boots
Service and maintenance
Regular maintenance is a prerequisite for keeping
the machine a safe tool. Carefully follow the
operating instructions.
Use only authorized parts. Any damage or
malfunction caused by the use of unauthorized
parts is not covered by Warranty or Product
Liability.
Change damaged parts immediately.
Replace worn out components in good time.
For major service to the machine, contact
your nearest authorized Chicago Pneumatic
workshop.
When cleaning mechanical parts with solvent,
make sure that current health and safety
regulations are complied with and that
ventilation is satisfactory.
Machine tools
Keep the tools clean and in a good condition.
Check tools regulary and make sure that they
are sharp.
