02/04/2013
PM 2946 7002 09
Page 26 of 39
19.2 Modifying the Node ID
The Node ID can be changed; use a value between 1 and 31. When the function is
ON
, the parameters cannot be modified.
Change the function to
OFF
to change the node ID.
It is also possible to change the channels. The controller has 4 channels. When changing the channels, the controller can
act as a Mk IV controller (a previous version of the controller). To set the channels, go to the screen where the node ID is
visible.
1.
Press the Scroll button down (12).
The following screen appears.
2.
Press the
Enter
button (13) to modify the setting.
The utmost left value will blink.
3.
Change this value by using the
Scroll
buttons (12).
4.
Press the
Enter
button (13) to confirm.
5.
Change the other values in the same way, as required.
After modifying the settings, the screen may look as follows:
1
