Chicago Pneumatic CP 4131, Safety And Operating Instructions Manual

Page: 17 / 296

3. Insert the chisel shank into the cylinder, and
screw the retainer onto the cylinder with hand
force until it is tight.
A
CP 4130, CP 4132
1. Insert the chisel shank into the cylinder.
2. Slide the retainer over the chisel and on to the
cylinder.
3. Insert the lock coil (A).
CP 4131
1. Screw the retainer on the cylinder by hand until
it is tight.
2. Push the retainer sleeve upwards and insert
the chisel shank in the cylinder.
3. Release the retainer sleeve and make sure the
sleeve returns to its end position.
A
CP 4134
1. Slide the retainer over the chisel and onto the
cylinder.
2. Insert the lock coil (A).
3. Push the retainer sleeve upwards and insert
the chisel shank in the cylinder.
4. Release the retainer sleeve and make sure the
sleeve returns to its end position.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
►
Stop the machine immediately in all cases of
power supply interruption.
Start and stop
A
B
C
D
The CP0016, CP4130 and CP4131 models are
equipped with a throttle lever and a lock-off trigger.
The lock-off trigger is positioned inside the D-
handle. It locks the throttle lever (positioned on top
of the D-handle) and prevents the machine from
starting accidentally.
◆
Start the machine by pulling the lock-off trigger
to position (A) and squeezing the throttle lever
towards position (C).
◆
Stop the machine by releasing the throttle lever
and the lock-off trigger. The throttle lever will
automatically return to position (D) and the lock-
off trigger will return to position (B).
CP 0016, 4130, 4131, 4132, 4134 Safety and operating instructions
9800 0616 71 | Original instructions 17