SKU 93808
For technical questions, please call 1-800-444-3353.
Page 6
English
10.
Never use damaged or incorrect blade washers or bolts
. The blade washers
and bolt were specially designed for your saw, for optimum performance and safety
of operation.
11.
Causes and Operator Prevention of Kickback
:
Kickback is a sudden reaction to a pinched, bound, or misaligned saw blade, causing
an uncontrolled saw to lift up and out of the workpiece toward the operator. When
the blade is pinched or bound tightly by the kerf closing down, the blade stalls and
the motor reaction drives the unit rapidly back toward the operator. If the blade
becomes twisted or misaligned in the cut, the teeth at the back edge of the blade
can dig into the top surface of the wood causing the blade to climb out of the kerf
and jump back toward the operator.
Kickback is the result of tool misuse and/or incorrect operating procedures or
conditions and can be avoided by taking proper precautions as given below:
12.
Maintain a firm grip on the saw and position your body and arm in a way that
allows you to resist KICKBACK forces
. KICKBACK forces can be controlled by
the operator, if proper precautions are taken.
13.
When blade is binding, or when interrupting a cut for any reason, release the
trigger and hold the saw motionless in the material until the blade comes to a
complete stop. Never attempt to remove the saw from the work or pull the saw
backward while the blade is in motion or KICKBACK may occur
. Investigate
and take corrective actions to eliminate the cause of blade binding.
14.
When restarting a saw in the workpiece, center the saw blade in the kerf and
check that teeth are not engaged into the material.
If saw blade is binding, it
may walk up or KICKBACK from the workpiece as the saw is restarted.
15.
Support large panels to minimize the risk of blade pinching and KICKBACK
.
Large panels tend to sag under their own weight. Supports must be placed under
the panel on both sides, near the line of cut and near the edge of the panel.
16.
Do not use dull or damaged blade
. Unsharpened or improperly set blades produce
narrow kerf causing excessive friction, blade binding, and KICKBACK.
17.
Blade depth and bevel adjusting locking levers must be tight and secure before
making cut
. If blade adjustment shifts while cutting, it will cause binding and
KICKBACK.
18.
Use extra caution when making a “Pocket Cut” into existing walls or other
blind areas
. The protruding blade may cut objects that can cause KICKBACK.
19.
WARNING!
People with pacemakers should consult their physician(s) before
using this product. Operation of electrical equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
20.
WARNING!
Some dust created by power sawing, grinding, drilling, and other
construction activities, contain chemicals known (to the State of California) to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals
