Page 10
For technical questions, please call 1-800-444-3353.
SKU 92880
You must use personal safety equipment
5.
including, but not limited to, ANSI-
approved eye and hearing protection, as
well as heavy work gloves.
Before beginning work, provide for
6.
sparks and debris that will fly off the
work surface.
CAuTIOn:
Always have
access to a type AAA fire extinguisher.
SET-up
Inserting a Bit in the Tool
note:
Only use accessories that are rated at
or above the RPM rating of the Cordless
Rotary Tool.
WARnIng:
Always allow the motor to come
to a complete stop before engaging the
spindle lock.
WARnIng:
Always remove the battery
pack before making any adjustments
or changing bits, to prevent accidental
starting of the tool. Accidental starting of
the tool may result in serious personal or
property injury.
Figure 10
1.
Depress the Spindle Lock (10). Rotate
collet until shaft is engaged by the lock.
Loosen the Collet Nut (1) by turning it
2.
counterclockwise, using the Wrench
provided.
WARnIng:
If you are changing a bit
immediately after use, be careful not to
touch the bit. It may be very hot from
use, possibly causing injury. Allow the bit
time to cool before handling it.
To remove a bit:
3.
Pull the bit straight out
of the Collet once the Collet Nut is loose.
To insert a bit:
Insert the shank end if the
bit into the Collet once the Collet Nut is
loose.
Collet Nut
Collets
Figure 10
nOTE:
Your tool is provided with two collets,
1/8” and 3/32” diameter. These are
precision manufactured to fit comparably
sized bits. Do not force a bit into the
wrong sized collet, and do not modify a
mismatched collet or bit.
Severe personal or property damage
may result from using mismatched
collets or bits.
Tighten Collet Nut securely using the
4.
provided wrench. Ensure that the spindle
lock is released before turning on the tool.
WARnIng:
Be sure the Collet Nut is tight
before turning on the tool. Bits may be
ejected from a tool if the Collet Nut is loose,
potentially causing severe personal or
property damage.
Installing the Flexible Shaft
Be sure that the Rotary Tool is turned
2.
OFF (the “O” position), and that the
Battery is removed from the Handle
before attaching the Flexible Shaft
Attachment (26).
Remove any bits that might be installed.
3.
Remove the Collet Lock Nut and the
Collet.
Remove the Collar or LED Collar from the
4.
tool Body by turning it counterclockwise.
REV 10e
