Page 11
skU 92280
For technical questions, please call 1-800-444-3353
3. locate the axles (24) and slide them into each axle retainer. refer to the photo at the
bottom of page 10.
4. align the side mounting hole of the axle with the hole in the axle retainer.
5. Place a Hex Bolt (27) into the bottom of the Frame, through the axle retailer, and
screw into the top nut. securely tighten.
6. Before mounting the Wheels (25), ensure that they are inflated to a pressure between
15 and 20 Psi. Pressures over 24 Psi could cause the tire to burst.
7. slide the Wheel over the axle and lock in place by placing the Cotter key (32) into the
end of the axle. Bend the Cotter key to keep it from falling out. see the illustration at
the bottom-right of page 10.
8. repeat steps 4 through 7 on the other axle and Wheel.
9. Using the front Handles (11), lift the Generator high enough to remove the two blocks.
front Support Bracket Installation
1. Using the front Handles (11), lift the Generator high enough to place the two six inch
blocks under the Frame (4) at the cross bar. see illustration below.
2. if not already installed, mount the rubber Foot into the Front support Bracket (26) as
shown below. securely tighten.
3. attach the Front support Bracket (26) to the underside of the cross bar using two Hex
Bolts (29) and two Hex nuts (28). securely tighten.
4. Using the front Handles (11), lift the Generator high enough to remove the two blocks.
Front support
Bracket (26)
rubber Foot
Hex Bolt (29)
Hex nut (28)
Muffler Installation
1. Find the Muffler and verify that the Flange Gasket is present. Refer to the illustration
at the top of page 12.
2. Mount the Muffler Inlet (with Gasket) to the Engine (2) exhaust manifold using two M8
x 1.25” Bolts (supplied). Before tightening Bolts, verify that the gasket is centered on
the exhaust manifold.
3. Slide the Muffler Cover (19) over the Muffler and secure with eight M6 x 1” Screws
(48). refer to the photo at the top of page 12.
