SKU 91007
PAGE 12
To Operate The Hammer Drill/Driver:
1.
The Hammer Drill/Driver is equipped with a keyless Chuck (4). To install a Drill
Bit (34), Hex Driver (35), or Hex Driver Extension (36), set the Forward/Reverse
Switch (29) to the center (locked) position. Hold the Chuck Sleeve firmly while
turning the Chuck counterclockwise until the opening is large enough to accept a
Bit, Driver, or Extension. Insert the Drill Bit, Hex Bit, or Hex Driver Extension and
turn the Chuck clockwise until it is locked on the Bit. Reverse this procedure to
remove the Bit, Driver, or Extension. (See Figure F.)
2.
Slide the fully charged Battery (28) into the bottom of the Hammer Drill/Driver’s
Handle. (See Figure F.)
3.
Check the Forward/Reverse Switch (29), and select the desired rotation of the
tool. For clockwise rotation, depress the Forward/Reverse Switch located on
the left side of the Hammer Drill/Driver. For counterclockwise rotation, depress
the Forward/Reverse Switch located on the right side of the Hammer Drill/Driver.
Use the Forward/Reverse Switch only after the Hammer Drill/Driver has come to
a complete stop. (See Figure F.)
SIDE VIEW
FRONT VIEW
RED
CHARGING
INDICATOR
LIGHT
GREEN CHARGED LIGHT
SET BUTTON
BATTERY (28)
BATTERY CHARGER (33)
FIGURE E
CHUCK SLEEVE
CHUCK (4)
FORWARD/REVERSE
SWITCH
(29)
TRIGGER
SWITCH
(26)
IMPACT CLUTCH (6)
TORQUE ADJUSTER (17)
BATTERY (28)
CARRYING STRAP (31)
FIGURE F
