UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 16
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagram on page 16.
To Charge The Battery:
SKU 91007
PAGE 11
1.
NOTE: The Battery (28) requires charging. The first charge requires 1-1/2 hours
charge time prior to using the cordless tool. (See Figure E, next page.)
2.
The Battery (28) should only be re-charged when the cordless tool begins to run
slowly. (See Figure E.)
3.
When the Battery (28) requires re-charging, a 1-1/2 hour charge allows the tool
to operate at full power. Do not re-charge the Battery longer than 1-1/2 hours, as
damage to the Battery and/or cordless tool will occur. (See Figure E.)
4.
To charge the Battery (28), slide the Battery firmly into the
Charging Socket of the
Battery Charger (33). Then, plug the Battery Charger into the nearest 120 volt,
grounded, electrical outlet. (See Figure E.)
5.
Press the SET Button on the Battery Charger (33) to begin charging.
(See Figure E.)
6.
Verify that the RED Charging Indicator Light comes on. If it does not illuminate,
check the power connection or try a different electrical outlet. Charge the Battery
(28) for 1-1/2 hours. NOTE: When the Battery is fully charged the RED Charg-
ing Indicator Light will turn off, and the GREEN Charged Light will illuminate.
Subsequent charging can also be done in 1-1/2 hours. (See Figure E.)
7.
While charging, the Battery (28) and Battery Charger (33) may become warm to
the touch. This is normal, and does not indicate a problem. (See Figure E.)
8.
Once the Battery (28) is fully charged, disconnect the Battery Charger (33) from
the electrical outlet. Then, disconnect the Charger Plug from the Battery
(See Figure E.)
9.
NOTE: If charging more than one Battery (28), allow the Battery Charger (33) to
cool down before reusing.
