Page 9
For technical questions, please call 1-800-444-3353.
SKU 90287
Maintenance
changing the Wheel
Change the GRINDING WHEEL (6) if
1.
grooves or ridges mar the evenness of
the grinding surface.
Figure 4 — Removing the Screws
Adjusting Knob (1)
Screw
(3)
Screw
(3)
2. Remove the two SCREWS (3). See
Figure 4.
Remove the Index Head Assembly (1, 2,
3.
& 7).
Remove the Wheel Assembly. Make sure
4.
the SPRING (10) stays in place. Refer
to the Parts Diagram if necessary.
Unscrew the ADJUSTMENT CYLINDER
5.
(4) from the WHEEL BASE (7) by turning
clockwise.
Pry out the WASHER (5).
6.
Pop out the WHEEL BASE (7).
7.
Press new WHEEL (6) onto WHEEL
8.
BASE (7), replace WASHER (5), and
screw CYLINDER (4) back in.
Replace Wheel Assembly onto unit.
9.
Make sure that the inner flats of the
ADJUSTMENT CYLINDER (4) match the
outer flats of the DRIVE SPINDLE (11).
Replace the DRILL
10.
INDEx and
SCREWS (3).
cleaning
Keep the surface of your unit free of grit,
1.
dirt, and grease. Use soapy water or
non-toxic solvents. Do not use petroleum
based solvents.
Keep the air vents free of foreign matter
2.
at all times.
Operation troubleshooting
If the motor turns on, but the wheel does
1.
not spin, make sure the ADJUSTMENT
CYLINDER’S (4) inner flats are even
with the outer flats of the SPINDLE (11)
as described in “Maintenance, Changing
the Wheel”.
It the motor does not turn on, it needs
2.
to be serviced or replaced by a qualified
technician.
