SpeCiFiCationS
Motor
120 V~ / 60 Hz / 1.4 HP
n
0
5000/min
Blade
8-1/4” Diameter, 5/8” Arbor
Cutting Capacity
At 90° x 90°: 2-3/8” x 4 3/8”
At 45° x 45°: 1-1/2” x 3-5/64”
At 45° x 90°: 1-1/2” x 4-3/8”
At 90° x 45°: 2-3/8” x 3-5/64”
Miter Angle Range
0° - 45° to right and left
5° increments
Bevel Angle Range
0° - 45° Left cut only
Blade Tilt Range
0° - 45° right and left miter
0° - 45° Left bevel
Blade
8-1/4” x 5/8” x 40T
6000 RPM Max
Accessories
included with Saw
8-1/4” Blade
Hex Wrench
Dust Collection Bag
Accessories
Table Extension Supports
and Project Clamp
E105017
unpaCking
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at
1-800-444-3353 as soon as possible.
initial Set up
inStruCtionS
read the entire important
SaFetY inFormation section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
to preVent
SeriouS injurY
From aCCidental
operation:
turn the power Switch of the
tool to its “oFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note:
For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
assembly
attaching the table extension Supports
and project Clamp (sold separately,
Sku 67451)
Insert the ends of the Extension Sup-
1.
ports into the holes in the sides of
the Base. Tighten the Wing Screws
to hold the Extensions in place. The
upper edge of the Extensions will be
level with the surface of the saw. This
provides a wider base for the work
material to rest on.
Insert the Project Clamp into the
2.
slot indicated in Figure 1 and lock in
place with the wing nut. Secure the
work piece to the saw table using
the Clamp. Securing the work piece
warning
Page 9
For technical questions, please call 1-800-444-3353.
SKU 67411
