Once the bevel angle is adjusted,
5.
adjust the Bevel Angle Indicator to
read 0º when the Saw Blade is in the
vertical position. Loosen the screw
holding the Indicator in place, adjust
it to be exactly over the 0º mark, then
retighten the screw.
adjusting or replacing the kerf
board
If the Kerf Board becomes damaged
1.
it must be replaced.
Remove the two Bolts (82) holding
2.
the Fence (83) in place and remove
the Fence.
Remove the three screws holding the
3.
Kerf Board in place.
Install a new Kerf Board. Replace
4.
the three screws and tighten them
slightly.
To adjust the Kerf Board, lower the
5.
Saw Blade and lock it down with the
Locking Pin. Adjust the Kerf Board
so the right side of the Blade slightly
clears the edge of the Kerf Board.
Loosen the Bevel Knob (71) and set
the Bevel Angle at 45º left. Ensure
that the left side of the Blade clears
the Kerf Board. Tighten the four
screws holding the Kerf Board in
place.
Replace the Fence.
6.
Cleaning and lubricating the
miter Saw
Observe the Dust Bag while using
1.
the saw. Empty the sawdust into an
appropriate container when the bag
is full.
Occasionally wipe or blow off
2.
sawdust that accumulates on the
saw. Saw dust on the Fence can
cause you to make inaccurate cuts.
Occasionally lubricate the pivot point
3.
of the Table as well as other moving
parts with a dry lubricant.
Page 17
For technical questions, please call 1-800-444-3353.
SKU 67411
