SKU 45416
Page 6
REV 04/02
The customer will need to supply the following hardware (not included):
1) (4) Grade 3, 5/16” -18 x 1-1/4”L hex-head bolts
2) (4) 5/16” -18 hex nuts
3) (4) 5/16” lock washers
4) (4) 5/16” flat washers
INSTRUCTIONS – INSTALLING GENERATOR/ALTERNATOR ON MOUNTING PLATE
1) Remove both fan covers (part# 26) from shaft end of generator/alternator.
2) Remove wiring box (part# 10) from opposite end of generator/alternator shaft.
3) Place generator/alternator so that through holes on bottom of generator/alternator are
readily accessible (facing up).
4) Place mounting plate, with countersinks holes facing up, on bottom of generator/
alternator and line-up holes on mounting plate and generator/alternator.
5) Insert one (1) 5/16”-18 hex-head bolt in each through hole in mounting plate and
generator/alternator. Insure that heads of bolts are below the surface of the mounting
plate.
6) Place one (1) flat washer, lock washer and hex nut on each bolt and tighten.
7) Turn and place generator/alternator back on mounting plate.
8) Replace both fan covers (part# 26) and wiring box (part#10).
This completes the installation of the mounting plate to the generator/alternator. Customer is
now to proceed to the Installation portion of the manual to complete the mounting of the
generator/alternator and mounting plate to generator frame. Again, it may be necessary for
the customer to further modify the mounting plate and generator frame to complete
installation.
MOUNTING PLATE
FOR
GENERATOR / ALTERNATOR 10KW
SKU 45416
