Page 5
For technical questions, please call 1-888-866-5797.
Item 44677
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.
Service
1.
Tool service must be performed only by qualified
repair personnel.
Service or maintenance performed
by unqualified personnel could result in a risk of injury.
2.
When servicing a tool, use only identical
replacement parts.
Use of unauthorized parts
or failure to follow maintenance instructions
may create a risk of electric shock or injury.
Specific Safety Instructions
1. Do not direct spray at people or animals.
2. Do not exceed maximum air pressure.
3. Do not spray near open flames, pilot lights, stoves,
heaters, the air compressor, or any other heat source.
Most solvents and coatings are highly flammable,
particularly when sprayed. Maintain a distance of
at least 25 feet from the air compressor. If possible,
locate the air compressor in a separate room.
4. Read all of the information concerning coating products
and cleaning solvents.
Do not use chlorinated
solvents (e.g. 1-1-1 trichloroethylene
and dichloromethane, also known as
methylene chloride) to clean spray guns.
Many spray guns contain aluminum,
which reacts strongly to chlorinated solvents.
Contact the solvent or coating manufacturer as
needed regarding potential chemical reactions.
5. RISK OF INJECTION - Do not point spray gun at
any person or any part of the body. In case of skin
injection, seek medical attention immediately.
6. Industrial applications must follow OSHA requirements.
7. Spraying hazardous materials may result in serious
injury or death. Do not spray pesticide, acid,
corrosive material, fertilizer, or toxic chemicals.
8. Paints and solvents may be harmful or fatal if
swallowed or inhaled. Avoid prolonged skin
contact with solvents or paints as they will
irritate skin. After any contact, immediately
wash off exposed area with hot, soapy water.
9. Attach all accessories properly to the tool before
connecting the air supply. A loose accessory
may detach or break during operation.
10. Install an in-line shutoff valve to allow immediate
control over the air supply in an emergency,
even if a hose is ruptured.
11. Air hose fittings may get hot during use.
Allow fittings to cool before disconnecting.
12. WARNING: Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities, contains chemicals known to the State of
California to cause cancer and birth defects or other
reproductive harm. Some examples of these chemicals
are:
• Lead from lead-based paints
• Crystalline silica from bricks and cement or other
masonry products
• Arsenic and chromium from chemically treated
lumber
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are
specially designed to filter out microscopic particles.
(California Health & Safety Code § 25249.5,
et seq.
)
13. WARNING: The brass components of this product
contain lead, a chemical known to the State
of California to cause cancer and birth defects
or other reproductive harm. (California Health
& Safety Code § 25249.5,
et seq.
)
