Page 11
For technical questions, please call 1-888-866-5797.
Item 44677
NOTICE
Clean the Spray Gun IMMEDIATELY after EVERY use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
Latex paint hardens quickly and permanently inside Spray Gun.
Sprayer Controls
To adjust the spray pattern
, loosen the Lock Ring (9)
by turning it counterclockwise, then rotate the Air
Cap (8), then retighten the Lock Ring (9). For a vertical
spray pattern, the “ears” of the Air Cap (8) should be
horizontal. For a horizontal pattern, the “ears” should be
vertical. In other words, the position of the Air Cap and
the spray pattern are at a 90° offset from one another.
To control the amount of paint mixture being sprayed
,
adjust the Adjusting Screw (4). Turning the Knob clockwise
will reduce the amount of paint, turning it counterclockwise
will increase the amount of paint available.
CAUTION:
Do not overtighten the Knob, as this will cut off
the paint supply, and may damage the Fluid Tip/Needle (7).
To change the Fluid Tip and Needle (7):
The
Fluid Tip and Needle (7) must both be the same
size. Check to make sure that they fit together
properly before installation. Typically, a larger Tip/
Needle would be required for thicker material.
1.
Make certain that the unit is shut off,
disconnected from the power supply
and clean before proceeding.
2. Loosen and remove the Lock Ring (9), Air
Cap (8), and Fluid Tip (7). Be careful not to
allow any parts to fall out of the gun.
3. Remove the Fluid Adjusting Screw (4), along with
the Spring (3) and Fluid Needle (7) underneath
it. Insert the desired Fluid Needle (7), and reinsert
the Spring (3) and the Fluid Adjusting Screw (4).
4. Assemble the matching Fluid Tip (7),
Air Cap (8), and Lock Ring (9).
5. The sprayer controls will require readjustment
after this procedure is complete. See page 9.
Basic Function Instructions
Refer to the diagram on page 9 for these instructions:
1. Attach the Hose to the Hose Fixture of the Main
Housing, by pressing it in and turning to tighten.
2. Attach the Hose to the Spray Gun by inserting the
Hose into the fitting, and turning it to tighten.
3. Thin the paint according to the manufacturer’s
instructions. Pour the paint mixture through a
cheese cloth or paint strainer into the Spray Gun.
4. Press the Switch to the ON position.
5. Point the Spray Gun where desired, and squeeze
the Spray Gun Trigger to begin painting.
6. Release the Spray Gun Trigger to stop painting.
7. Move the Switch on the Main Housing to the
OFF position to turn off the compressor.
