SKU 08886
PAGE 11
5.
TO CLEAN, wipe with a clean, damp cloth. If necessary, a mild detergent may
be used.
6.
Charging room temperature: 50
o
F - 104
o
F. NiCad batteries must be
recyled or disposed of properly. Do not short terminals.
Do not incinerate. Risk of electic shock; use only in dry location.
Only use with battery packs distributed by Harbor Freight Tools; others
may burst, causing personal injury and/or property damage. If battery pack
is cracked or damaged in any way, do not insert it in charger.
For additional information on battery re-cycling call 1-800-822-8837.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY
DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT
HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS
QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTUER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER
ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER INSTALLATION OF REPLACE-
MENT PARTS THERETO.
4.
TO REPLACE THE BATTERIES: Always make sure the
two Batteries (part #13)
are replaced at the same time. To replace the Batteries, unscrew and remove
the ten phillips
Screws that hold the Back Cover in place. Remove the Back
Cover to expose the
Battery Compartment. Remove the two Holding Brackets.
Carefully lift the two Batteries out of the Battery Compartment. Remove the
Copper Booster Cables (parts #1, #2) and the
Red and Black Recharging Wires
from the Battery Terminals. Make sure the Red Copper Booster Cables and Red
Recharging Wires are attached to the Positive (+) Battery Terminals. Then,
attach the Black Copper Booster Cables and Black Recharging Wires to the
Negative (--) Battery Terminals. Carefully slide the two new Batteries back into
the Battery Compartment. Replace the two Holding Brackets to secure the
Batteries in place. Position the Back Cover back in place, and secure the Back
Cover with the ten phillips Screws.
new Light Bulb. Then, snap the Light Lens and Light Case back into place.
