Chicago Dryer King Edge VAc, Instruction Manual

Page: 72 / 302

Preventive Maintenance King Edge Vac
4-18
Check and Grease Bearings
Regularly grease bearings to help ensure
smooth operation and dependability. It is
important that only Shell Darina
®
EP2 Grease or
its equivalent be used.
Use of unsuitable grease can cause bearing
lockup or failure. Problems can also result if the
new grease is incompatible with the grease that is
already in the bearings. Failure to use the correct
lubricant will void the factory warranty.
CAUTION
Before using a grease
other than Shell Darina
®
EP2, check with the factory
service department to
verify that the grease
meets specifications and is
compatible with the grease
already in the bearings.
Be sure to grease the: (Figure 4-27)
Four spreader belt shaft bearings in each
endframe (A).
ByPass conveyors drive roll bearings in
each inside endframe (B).
Clutch roller upper pulley shaft bearings
(C) at each end.
Clutch shaft bearings (D) at each end of
the clutch shaft.
•
•
•
•
Figure 4-27: Roll bearings with grease fittings are
located throughout the unit.
A
A
B
C
A
A
B
D
TOC INDEX