2.
To access the battery ,pull out the battery cover as shown in Fig.2.
Belt-Pack Transmitter(M-1001)
3.
Insert a 9V battery with correct polarity into the battery compartment and put back
the compartment cover, as shown in Fig.3.4.
1.
The Belt-Pack transmitter is shown in Fig.1.
Fig.1
Fig.2
Fig.3
Fig.4
(Q-1002)
HAND-HELD Microphone
Battery status
LED indicator
Metal grille
( Capsule module inside )
Handheld Microphone
Parts and Functions
Power switch
Battery compartment
cover
Press
Fig.1
Fig.2
Battery Installation
Fig.3
4
3
Female connector
Headset microphone
Battery status indicator
Mike clip
Lavalier microphone
As soon as the switch is on, the battery-status indicator will give a flash to indicate
a normal operation. If there is no flash, it indicates either power supply is not
available or battery is installed wrongly.
After switching on, the Therefore signal indicator LED(s) of matching transmitter
will light up to indicate the transmission of the microphone signal is in normal
operation.
Switch off the power when the microphone is not in use, meanwhile, remove the
battery out of the microphone if it is not to be used for an extended period.
Q-1002
uses 1 piece of 9V battery. To install new or replace the old battery, First unscrew the battery
cap
from the battery compartment, then insert the new battery according to its correct polarity as
indicated. For longer Operation hour, Alkaline battery is recommended!