ISO 9001
｜
ISO 14001
｜
OHSAS 18001
-10-
Note
: Batteries contain a corrosive acid that may leak and damage the belt-pack when stored
for a long period. Batteries should be removed from the belt-pack before storing without use for
more than 4 weeks.
When the microphone is switched ON, the battery power LED (red) will blink once to indicate
the batteries installed are in good condition.
If the LED remains illuminated the batteries
have expired and require replacement.
Channel synchronizing of the receiver and transmitter
1. Limit the distance between the receiver and transmitter within 30cm.
2. Align both sensor areas
3. To change the receiver
’s channel, please press the synchronizing button of the transmitter.
The transmitter will transmit synchronizing signal to the receiver and change its channel.
4. To change the transmitter
’s channel, please press the synchronizing button of the receiver.
The receiver will transmit synchronizing signal to the transmitter and change its channel.
GAIN setting (GT/MT)
Gain control enables the user to set different output levels. GT is for the use of instrument with
high impedance, such as guitar while MT is for the use of low impedance such as lapel or
headset microphones.
Other settings
（
SM-7100 IrDA/SM-6100 IrDA
）
1. Channel setting
Use
MENU
button to go to the
CHANNEL/ FREQUENCY
page.
︰
After pressing the
SET
button for 3 seconds, the cursor will flash to allow changes to be made.
Pressing
SET/MENU
buttons will increase/decrease the channel number. The corresponding
frequency will change accordingly. 3 seconds after selecting a channel, it will be automatically
saved.
2. Battery type setting
Use
MENU
button to go to the
BATTERY TYPE
page.
︰
After pressing the
SET
button for 3 seconds, the cursor will flash to allow changes to be made.
Press
SET
button to select either
NiMH
(rechargeable battery) or
AKLN
(alkaline battery). 3
seconds after selecting a battery type, it will be automatically saved.
Remark:
NiMH
battery must be selected when rechargeable battery is being used. Never select
AKLN
(alkaline) when transmitter is intended for charging as alkaline battery isn
’t rechargeable.
Wrong battery selection will result in battery sensing electronics to display wrong and
misleading status information.
