background image

Do  not  wear  it
underneath  a  jacket
or  inside  the  pocket.

Do  not  cover  the
IR  emitter.

IR  emitter 
should  not  be
blocked. 

Connection diagram

A.Basic System

B.Extended System(multimedia version)

Inserting battery in handheld microphone 

Power  selector  position

LO  position

HI  position

Operating  range

Battery  life  (  NiMH  )

About  20  m

About  30  m

About  6  hours

About  4  hours

Handheld Microphone IWH-201

1.Grille cover.
2.Status LED: Bicolor LED will glow  when switch is put to ON :
   Green : Battery is  full and transmitter is in normal mode.
   Red  : Battery is weak and will shut off soon. Please charge the battery.
3.Power switch
   Slide to turn microphone on or off.
4.Battery compartment.
5.Infrared emitter with charging contacts. 
   IR ray radiates from here. Do not block or hold this part of the body.
6. ( HI / LO ) .Power Selector Switch. Factory preset is LO.

4

5

6

To insert new or take out old battery, simply turn the battery compartment cover in 
counterclockwise direction and pull it open as illustrated.
Make sure that  the power switch is in  OFF  position when taking out or installing 
new battery. Insert the supplied battery into the battery compartment, aligning the 
battery with the correct polarity symbol. If battery is inserted wrongly, the 
transmitter will not be powered.

For multimedia application, the audio out 
of the laptop computer output is fed into 
the Line In of the IWA-300 and the 
teacher or presenter can use the IR 
transmitter for sound enforcement. 

10

3

Summary of Contents for IWA-300









Reviews: