Adding Washer Fluid
Your vehicle has a low washer fluid message that
comes on when the washer fluid is low. The
message is displayed for 15 seconds at the start
of each ignition cycle. When the CHECK WASHER
FLUID message is displayed, you will need to
add washer fluid to the windshield washer
fluid reservoir.
Open the cap with the
washer symbol on it.
Add washer fluid
until the tank is full. See
Engine Compartment
Overview on page 476
for reservoir location.
Notice:
•
When using concentrated washer fluid,
follow the manufacturer’s instructions
for adding water.
•
Do not mix water with ready-to-use washer
fluid. Water can cause the solution to
freeze and damage your washer fluid tank
and other parts of the washer system.
Also, water does not clean as well
as washer fluid.
•
Fill your washer fluid tank only
three-quarters full when it is very cold.
This allows for expansion if freezing
occurs, which could damage the tank
if it is completely full.
•
Do not use engine coolant (antifreeze) in
your windshield washer. It can damage
your washer system and paint.
512
Summary of Contents for 2007 Silverado 1500 Pickup
