MINIMUM ROOM SPACE FOR MACHINE OPERATION
OPERATION
OPERATION STEPS
1.
Raise the saw head to a vertical position.
2.
Adjust the motor automatic stop key so the motor will stop when the workpiece is cut off.
3.
Adjust the stock stop to the desired length position.
4.
Open the vice to accept the workpiece to be cut. If the piece is long in length, it will require
some support.
5.
Rotate the hand wheel to tighten the work piece.
6.
Turn on the switch, and change the blade speed to best suit the workpiece being cut.
7.
Let the saw head down slowly to touch the workpiece lest the blade should be broken by
excessive pressure.
8.
Rotate the adjusting rod to obtain the correct pressure.
HELPFUL CUTTING HINTS
1.
The harder the material, the slower the cutting speed should be.
2.
Use of cutting oil is recommended when the blade speed is higher.
3.
To increase the feed, turn the feed screw adjustment (at the left of the base) counter clockwise:
to decrease turn clockwise. Do not adjust more than one turn at a time.
Chester UK HV128 Bandsaw
7
