Place the right angle gauge on the bed to adjust the blade vertical angle. If the blade is not vertical to the
right angle gauge, adjust the blade adjustable seat according to Fig. 1.
When the blade is vertical to the bed, adjust the mitring vice plate to the right angle, on the basis of right
angle gauge against the blade (as above, the clamping face of the mitring vice must be on a line with the
scale).
Method of adjusting the blade:
A.
Loosen the screw #11.
B.
Adjust the blade adjustable seat #64 to make the blade vertical to the bed.
C.
Place the square on the bed to check if the blade is vertical, if not, repeat the process A
to C.
D.
Tighten the screw #11.
MAINTENANCE
That’s easier to keep machine in good condition or best performance by means of maintaining it, than
remedy it after it is out of order.
1.
Daily Maintenance (by operator)
(a)
Fill the lubricant before starting machine everyday.
(b)
If the temperature of the spindle caused overheating or a strange noise, stop the
machine immediately to check.
(c)
Keep the work area clean, release vice, cutter, workpiece from table, switch off the
power source and clean chip / dust away from the machine. Then follow instructions
on lubrication before leaving.
2.
Weekly Maintenance
(a)
Clean and coat the leading screw with oil.
(b)
Check to see if the sliding surfaces and turning parts lack lubricant (lubricate if so).
3.
Monthly Maintenance
(a)
Check if the fixed parts are loose.
(b)
Lubricate bearing, worm and the worm shaft to avoid wear.
Chester UK HV128 Bandsaw
11
