axxys
®
evolution
is a contemporary range of stair balustrade designed to inspire.
As a modular system
axxys
®
evolution
provides the flexibility to blend components
from across the range to create a stylish, bespoke staircase and a focal point for any
living space. Clean lines and metallic details also allow
axxys
®
evolution
to make a
modern statement within more classic, period environments.
axxys
®
evolution
has been designed not only for its quality and style, but also for its
simplicity to install. All components have been independently tested to conform to
UK building regulations, are design registered and patent pending.
Cheshire Mouldings
axxys
®
evolution
stair balustrade is a UK and International Patent and Design
Registration pending product, blending traditional turnings with modern materials. Hand and base rails
are assembled using our unique metal brackets. Balusters are fixed into place using our patented fully
adjustable baluster brackets which adjust between 90
o
and 45
o
, locking firmly into place when positioned
into the Hand and Base rail profile. These components once assembled form an innovative balustrade
solution that can be adjusted to suit any staircase pitch between 38
o
& 45
o
.
Please Note;
Cheshire Mouldings
axxys
®
evolution
is a factory pre finished system, therefore when handling and
installing please take extra care in order to not damage the finish.
Please Check;
All components should be inspected BEFORE installation commences for any damage, as Cheshire
Mouldings cannot be held responsible for any damage caused during installation.
axxys
®
evolution
is designed for use in domestic situations and will fit most closed stair cases achieving
minimum handrail heights of 900mm on the rake and 900mm on the landings. If your staircase is longer
than 3.9m on the rake, you must install an Intermediate Newel Base, Newel Post & Handrail Connector in
order to achieve the FIRA strength standards, instructions for this are on the following pages.
axxys
®
evolution
is manufactured to precise tolerances, however please be aware that timber is a natural
product and some distortion, expansion and sometimes shrinkage can occur.
If timber components (i.e. hand rails) are slightly oversize, gently sand or shave the timber until a tight fit
is achieved, being careful to only sand/shave the part of the component that is going to be concealed by
the metal or plastic connector.
If the timber component is slightly under size, the tolerance can be taken up by using a gap filling
adhesive.
