COATING HEAD
1.
Thumbscrews
2.
Gap Adjusting Screws
3.
Tension Screws (These secure the top coating bar to the Crossbar. They are set in the
factory and do not require any adjustment)
4.
Bottom Coating Bar
5.
Top Coating Bar
6.
Reservoir
7.
Crossbar
8.
Upright
SETTING COATING GAP
The follow directions will allow you to set the gap on the coating head to create a coating of a
desired thickness.
1.
With the power off and the heating elements at room temperature, remove the heating
element from the reservoir. There is a plate that holds the heating elements in place which
must be removed. The plate is held in place by two screws. Remove the screws and pull
out the heating element.
2.
Remove the reservoir.
3.
Tighten the bottom thumbscrews on either side of the bottom coating bar.
1
3
4
5
2
6
7
8
7
