Page 4
CLS-1200-2CH, Temperature Control Module
1.
Place Controller on a flat stable surface.
2.
Ensure adequate space around controller.
3.
Plug Controller into suitable electrical outlet.
4.
Place Vent Heater (if applicable) over Vent Filter and connect end to ‘Filter Vent Heater’
outlet on Front of Controller. Note- Position of Vent Heater.
5.
Insert RTD (Pt100 Sensor) plug into RTD receptacle.
6.
Plug Tray Heater cord into Power Outlet rated at 1200 watts
DO NOT USE TRAY HEATER WITHOUT A CULTURE BAG IN PLACE
SET-UP Guide (refer to Fig. 1, 2 & 3)
FRONT VIEW
REAR VIEW
Vent Filter
Vent Heater
Figure 1
–
Cell Culture Bag /Vent Heater
NOTE: Vent Heater must
be positioned to read
"THIS SIDE UP"
