Chelsio Communications Terminator 6, Installation And User Manual, Page: 221 / 432

Chapter XIII. Data Center Bridging (DCB)
Chelsio Unified Wire for Linux 221
iii. Configure the CEE interface as a Layer 2 switch port. Example of configuring the switch port
as a 10-Gigabit Ethernet interface.
switch(config)#interface tengigabitethernet 0/16
switch(config-if-te-0/16)#switchport
switch(config-if-te-0/16)#no shutdown
switch(config-if)#exit
iv. Create an FCoE VLAN and add an interface to it. Example of creating a FCoE VLAN and
adding a single interface.
switch(config)#vlan classifier rule 1 proto fcoe encap ethv2
switch(config)#vlan classifier rule 2 proto fip encap ethv2
switch(config)#vlan classifier group 1 add rule 1
switch(config)#vlan classifier group 1 add rule 2
switch(config)#interface vlan 1002
switch(conf-if-vl-1002 )#fcf forward
switch(conf-if-vl-1002 )#interface tengigabitethernet 0/16
switch(config-if-te-0/16)#switchport
switch(config-if-te-0/16)#switchport mode converged
switch(config-if-te-0/16)#switchport converged allowed vlan add 1002
switch(config-if-te-0/16)#vlan classifier activate group 1 vlan 1002
switch(config-if-te-0/16)#cee default
switch(config-if-te-0/16)#no shutdown
switch(config-if-te-0/16)#exit
v. Save the Configuration
switch#copy running-config startup-config
Unlike cisco, only one VLAN ID can carry FCoE traffic for now on Brocade 8000.
It is their limitation.
Note