4
• The Kettle is equipped with an electronic sensor, which detects temperature and shuts off the appliance
shortly after the boiling point is reached.
noTE:
This automatic shut-off mechanism turns the ”ON/OFF”
switch to the “OFF” position when the water boils.
• A short power supply cord is provided with this appliance to reduce the risk of someone becoming entangled
in or tripping over a longer cord and causing the Kettle to overturn, discharging its hot contents. While
EdgeCraft does not recommend it, extension cords are available and may be used if care is exercised in their
use. If an extension cord is used, it should be a grounded three conductor cord rated at not less than
15 amperes and match the configuration of the plug. The longer cord should be arranged so that it will not
drape over the countertop or tabletop where it can be pulled on or tipped over by children or the infirm.
• Plug base unit into a three way grounded 110-120 volt, AC outlet.
• The Kettle power switch (4) has 2 positions - “ON” (I) and “OFF” (O). Place Kettle on it’s base and press the
switch to the “ON” position. The switch will illuminate to indicate the power is on.
• The Kettle normally switches off automatically within about 30 seconds after the boiling point is reached.
• The time required for the Kettle to automatically switch off after the boiling point is reached will vary
depending on the amount of water in the Kettle.
• If only warm water is desired, you can interrupt the heating
procedure at any time by simply lifting the kettle off of
its power base. The power switch will shut “OFF”. In
order to restart the heating place the kettle on its power
base and press the ON/OFF switch. The switch will light
indicating that the power is on.
• The Kettle can be lifted easily from the base for pouring
or serving. The pouring spout has been specially
designed to easily pour even small amounts of water.
• Replace the Kettle on the base unit when finished pouring.
• Whenever the kettle is lifted off its base the power switch
must be pushed to the “ON” position again if you wish to
restart the heating of the water. Always check the water
level before pushing the power switch “ON”. Make certain
there are at least three cups (0.7 liters) of water in Kettle
before pushing switch “ON”. Avoid boiling the kettle dry.
• To pour, press down on dispensing lever (2), and tilt
the kettle.
•
once the kettle has reached the boiling point, and
shut off, it will not allow the switch back on until
water has cooled by a few degrees. This may take
several minutes.
The electronic sensor detects water
temperature and prevents overheating.
figure 1.
6
7
3
1
2
4
5
1. Lid
2. Dispensing Lever/Lid Release Lever
3. Base Unit
4. Power Switch Push “ON”, Push “OFF”
5. Handle
6. Spout
7. Stainless Steel Body
