Page 15
Simple Maintenance and Repair
DO NOT USE VEGETABLE OIL TO LUBRICATE SLICER.
VEGETABLE OIL WILL DAMAGE THE SLICER!
Sharpener Shafts
It is necessary to lubricate the sharpener shafts with Globe oil weekly.
1. Loosen the sharpener release knob and pull the sharpener up to remove it (Fig. 15-1).
2. Put several drops of Globe oil on the shaft behind each sharpening stone (Fig 15-2).
3. Push both sharpener buttons a couple of times to distribute the oil
onto the shafts.
4. Put several drops of Globe oil on the main shaft (Fig. 15-1), place the
sharpener back into position and tighten the sharpener release knob.
5. Wipe off any excess oil that drips onto the slicer.
NOTE: The sharpener and stones can be cleaned with warm water and a brush.
Allow it to air dry.
If the sharpener or stones are cleaned it is very important
that all sharpener shafts are lubricated with Globe oil afterwards!
End Weight Slide Rod
The end weight slide rod should be lubricated weekly or when excessive drag is
felt with a few drops of Globe oil.
1. Apply a few drops of Globe oil to the slide rod (Fig. 15-3).
2. Slide the end weight up and down to distribute the oil.
Globe recommends that an authorized Globe service
company perform all adjustments and major maintenance.
By adequately maintaining your slicer,
it will provide years of dependable service.
Figure 15-1
Figure 15-3
End Weight Slide Rod
Figure 15-2
Shafts
Sharpener Release Knob
Main Shaft
