Chef CKE5065W, Instruction Book

Page: 11 / 36

11
Electrical connections
Any electrical work required
to install this cooker and the
supply cable should be carried out
by a qualified licensed electrician,
in accordance with the current
regulations.
This cooker must be earthed.
The manufacturer disclaims
any responsibility should these
safety instructions not be carried
out.
Before any maintenance or
cleaning can be carried out, you
must DISCONNECT the cooker
from the electricity supply.
This cooker is designed to be
connected to a 240V/415V AC, 50Hz
electrical supply.
To connect to the electricity supply,
use cable type H05 RR-F.
Before connection, make sure the
electricity supply voltage is the same
as that indicated on the rating plate.
The cooker is supplied without supply
cable. A flexible supply cable must
be fitted, in accordance with the
specification give in the relevant table
no. 1.
The electrical connection should be
made using a double pole isolating
switch (cooker control switch) with at
least 3 mm contact separation in all
poles.
The cable must have conductors of
sufficiently high cross-sectional area
to prevent overheating or deterioration.
The switch should be sited within
2m of the cooker and be easily
accessible at all times.
The switch must not interrupt the
yellow-green grounding cable.
NOTE: The earth wire should be
about 2 cm longer than the live and
neutral wires.
After installation and connecting, the
cable must be placed so that it
cannot at any point reach a
temperature of more than 50°C
above the ambient temperature.
Before connecting check that:
•
The fuse and household
electrical installation can carry
the absorbed current of the
appliance (see rating plate);
•
The cooker connection outlet or
the cooker control switch is
easily accessible when the
appliance is installed.