USER'S MANUAL, NP10 AND NP20
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY
Document No. 10071753
Rev. 00
Page 14 of 14
the DC Power input (i.e. do not connect 2 power supplies directly to 1 reader). J6 and J14
are wired in parallel, allowing the installer to daisy chain a second RF Only system; use
only the approved power supply for your region; in FCC use 10043582. The third bottom
row connector port (J3) is for future expansion.
The DC power wire must be 3 conductor (2C w/ drain wire), 18 AWG or greater,
maximum 10m [32.8ft]. The PSU drain wire is grounded to chassis GND with crimp
terminal. A small bracket with ground lugs will be described in the installation manual.
The connector pinout for DC power INPUT connector is below:
Table 2: Power Connector Pin Assignments
PIN # ON TR4300 (J6/J14)
COLOR
SIGNAL
EXAMPLE
1
Bare wire (shield/
drain wire)
Chassis Ground
(GND)
2
Red
+24V
3
Black
GND
Note: Other internal factory wiring will be detailed in reference sections in the Field Service manual.
6.0
DEVICE LABELING
Each NEO will have a label, found in the base region, which indicates this specific unit’s
Model Name, part number, revision and the serial number of the unit manufactured, as
well as regulatory information. For example:
FCC ID: DO4NEO
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesirable operation.
