USER'S MANUAL, NP10 AND NP20
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY
Document No. 10071753
Rev. 00
Page 12 of 14
Light and Speaker Board continued…
Speaker 2-Pin mini jack (1): Hirose 2-Pin port, keyed
LED 7-Pin mini jack (1): Hirose 7-Pin port, keyed
System Controller Audio Input 3-Pin mini jack (1) Hirose 3-Pin port, keyed
USB Connector (1): USB Mini-C connector for interface to controller
3.5
IO Board (GPIO Module)
Mechanical Specs:
PCB Layers: 4
PCB Materials: FR4
Dimensions: 32.5mm X 76.5mm [1.28in X 3.01in]
Electrical Specs:
Inputs: 4. RJ-45 connector (2 pins per input).
Outputs: 2. The GPO RJ-45 connector has 4 relay contact pairs in total. 2 Normally Open
(N.O.) and 2 Normally Closed (N.C.). Each output drives an open and closed contact pair.
RS-232 serial data interface (intended only for support of CPiD-RF): 1
Connectors: 3 RJ-45, and 2 x 12 header male, pre-installed B2B with EAS Sensor.
3.6
Audio Speaker
Mechanical Specs:
Dimensions: 2” diameter
Square frame: OD of frame is approximately
Electrical Specs:
Impedance: 4 Ohm
Frequency response: Full range speaker (150 Hz - 20 KHz)
Terminals: Soldered
Wire type: 26 AWG PVC, stranded wires (Red and Black color)
Connector, Lights and Sound Board side (speaker output terminal): Hirose DF13-2S-1.25C
Crimp Terminals: Hirose DF13-2630SCFA(04), Qty 2.
