Series ATP Reciprocating Drive - Dual or Single Head
With Adjustable Stroke Length
Operating Manual
CP-MAN-PRD-ATP REV00 EFF. DATE 04/01/19
Page 3 of 12
1.
SYSTEM REQUIREMENTS
1.1
Inspection
1.1.1
Before installation, please inspect the pump carefully. If the pump appears to have sustained damage in
transit, call your CheckPoint Authorized Distributor or CheckPoint Customer Service directly at +1 (504) 340-0770
to report and confirm damage. If it is determined that damage occurred in transit, a carrier claim will be required.
1.2
Storage
The Series ATP pump has been thoroughly tested at the CheckPoint factory prior to shipment. This testing may
leave residual fluids in the pump head. Although our pumps can be placed in service without environmental
protection, we suggest that they are stored indoors until being commissioned.
1.3
Unpacking
The ATP pump can be shipped as a single-head or dual-head pump. Please ensure that unpackaged pumps are
securely placed in a safe area. Refer to the CheckPoint Quick Setup Guide for installation of the ATP pump.
1.4
Safety
The Series ATP can produce high rod loads. All CheckPoint pump heads used with the ATP are designed to
provide cover plates to minimize pinch points. Use of the ATP with another brand of pump head is not
recommended and may present safety hazards.
1.5
Location
1.5.1
For safe and continuous operation, locate the pump with supplied base on a stable surface with sufficient
access for the operator.
1.5.2
CheckPoint requires horizontal mounting for the Series ATP. Improper mounting could result in poor drive
performance and difficulty during priming. The Series ATP base is provided to ensure proper orientation.
1.5.3
The pump may be mounted to a skid or other surface in a number of ways; however, clamping around the
outside of the drive is not recommended. Proper mounting techniques increase accessibility during maintenance
and troubleshooting.
