Using the First Time Configuration Wizard
Quantum Spark 1530 / 1550 Appliance R80.20.XX Getting Started Guide | 19
n
Zero Touch service already completed.
n
The First Time Configuration Wizard already completed.
n
Zero Touch service is disabled.
Where applicable, click
Retry
now to connect again.
6.
After you connect to the server, the settings are automatically downloaded and installed. The status
is shown in the
Fetching settings from the cloud
window. It may take several minutes until the
installation is complete.
7.
Click
Finish
.
Note
- If a collision is detected between an internal network (LAN) and an IP returned using DHCP (WAN),
the conflicting LAN address is changed automatically. If a colliding LAN IP address is changed, a message
appears in the system logs.
When you reconnect to the WebUI or click
Refresh
, the browser opens to show the status of the installation
process.
After the gateway downloads and successfully applies the settings, it does not connect to the Zero Touch
server again.
Authentication Details
In the
Authentication Details
page, enter the required details to log in to the appliance WebUI, or if the
wizard terminates abnormally:
n
Administrator Name
- We recommend that you change the default "
admin
" login name of the
administrator. The name is case sensitive.
n
Password
- A strong password has a minimum of 6 characters with at least one capital letter, one
lower case letter, and a special character. Use the
Password strength
meter to measure the
strength of your password.
Note
- The meter is only an indicator and does not enforce creation of a password with a specified
number of character or character combination. To enforce password complexity, click the check
box.
n
Confirm Password
- Enter the password again.
n
Country
- Select a country from the list (for wireless network models).
The country where the license is set determines the wireless frequency and parameters, as the
regulations vary according to region.
If you are using a trial license, only
basic radio settings
, are allowed in all zones. A warning that
selected wireless radio settings are not applied shows on the
Summary
page and also on the
Device
>
License
page. For more information on basic wireless radio settings, see
If you select a country and install a valid license, but the wireless region of the device does not match
the selected country, a warning message shows and you must edit the country information. When
the country and wireless region match, you see the full settings.
