JU6-KBD
MIDI Interface for Juno-6 Keyboard
Model 8-429 ver. 1.0
Copyright © 2010 CHD Elektroservis.
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
6
In that case, MIDI-IN connector installation procedure is as follows:
a) Flip the front cover over and return it to its original closed position on top of the synth.
b) Drill three holes (one with 16 mm diameter and two with 3,5 mm diameter) in the rear panel
(see pic. 2.2-3). Work carefully so as to not drill the parts inside the instrument (pic. 2.2-4).
c) Clean the edge of the holes with small rasp (pic. 2.2-5). Also clean the holes from the inside
after the instrument opening..
d)
Clean all iron sawdust and raspings from the inside of the instruments
, they can cause
short circuits or serious electrical damage if left in the instrument. Please clean the instrument
carefully!
e) The visible silver edge should be colored with black cover (you can use permanent marker for
example) (pic. 2.2-6).
Pic. 2.2-5
Pic. 2.2-6
f) Insert the MIDI-In (DIN plug) in the back cover (from inside) and fix it with screws and nuts (pic.
2.2-7). Insert the flat washers under the heads of the screws and fan type washers under the nuts (pic.
2.2-8). All material is a part of the kit.
Pic. 2.2-7
Pic. 2.2-8
g) It is suitable to mark the connector („MIDI IN“) use e.g. self-adhesive foil (pic. 2.2-2).
