Battery Tester C.A 6630
English
34
6 USING THE MEMORY STORE FUNCTION
6.1
MANUAL STORAGE (999 LOCATIONS)
6.1.1
Storing measurement data in the memory
To store a measurement result in the memory: after the measurement has been
carried out, press M MEMORY; “DATA M NO XXX” is then displayed for 1 second,
indicating the number of the location where the result has been stored.
6.1.2
Reading stored data
To read stored data, press the R READ key; “DATA R NO XXX” is then displayed.
To select the location, press
and
.
To exit the memory read mode, press R READ again.
6.2
CONTINUOUS DATA STORAGE : DATA LOGGER MODE
(9600 LOCATIONS)
1. press the HOLD key for 2 seconds : INTV is then displayed.
Adjust the time interval (from 1 to 255 seconds) between 2 samples using the
and
keys.
To exit this program, press SET.
2. to activate the data logger mode, press the M MEMORY key for 2 seconds:
M is then displayed and flashes each time a sample is stored.
3. to stop the data logger mode, press the M MEMORY key.
Warning: the data recorded in data logger mode cannot be read directly from
the C.A 6630 itself. The recorded measurements must be transferred firstly to
a PC (software supplied with the instrument).
6.3
ERASING STORED DATA
When the memory is full, "Full" is displayed, indicating that further storage is
impossible.
To erase the stored data:
1. switch the C.A 6630 off by pressing
key.
2. then hold the M MEMORY key down while switching the C.A 6630 back on
(
key). Clr is then displayed to confirm the deletion of the stored data.
