Chauvet WELL GOBO, User Manual, Page: 16 / 21

Page 12 of 17
Operation
WELL Gobo User Manual Rev. 1
Master/Slave
The Master/Slave mode allows a group of WELL Gobo products (the slaves) to simultaneously duplicate
the output of another WELL Gobo (the master) without a DMX controller. To set each of the slaves:
1. Go to the Master/Slave main level.
2. Select Slave .
3. Go to Wireless Setting > Receive .
4. Select On .
To set the master:
1. Go to the Master/Slave main level.
2. Select Master .
3. Select a standalone setting or control with the IR remote.
Configuration (DMX)
Use control configurations to operate the product with a DMX controller. For information on how to
configure wireless DMX, see DMX Linking .
Control Personalities
This setting allows you to choose a particular control personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (see table below).
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1. Go to the DMX Address main level.
2. Select the starting address ( 001 – 511 ).
The highest recommended starting address for each DMX mode is as follows:
Wireless Settings
This mode allows the user to control the DMX wirelessly. For detailed setup of this feature, see Wireless
Operation . To disable this feature:
1. Go to Wireless Setting > Receive .
2. Select Off .
• The master is the one that runs a program whether in Auto, Static, or IR mode.
• Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
• Do not connect a WDMX transmitter to the products configured for Master/Slave
operation. The WDMX transmitter may interfere with signals from the master.
Personality Channels
6Ch 6 channels
3Ch 3 channels
2Ch 2 channels
1Ch 1 channel
• See the Starting Address section for the highest starting address you can select for
each personality.
• Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
Personality Address
6Ch 506
3Ch 509
2Ch 510
1Ch 511
Once a WDMX receiver has been linked to a specific WDMX transmitter, it will
remain linked to that specific transmitter until it is linked to a different one.