Page 11 of 17
WELL Gobo User Manual Rev. 1
Operation
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1. Go to the
Auto Show
main level.
2. Select the desired auto program (
Auto 1–4
).
3. Select the desired speed (
1–100
).
Static Mode
The Static mode allows for permanent dimmer and strobe presets without a DMX controller.
1. Go to the
Static
main level.
2. Select
Dimmer
or
Strobe
.
3. Set the desired output value (
0–255
)
Dimmer Profiles
This setting determines how fast the output of the WELL Gobo changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1. Go to the
Dimmer Mode
main level.
2. Select a dimmer curve (
Off
,
Dimmer 1
,
Dimmer 2
, or
Dimmer 3
).
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the WELL Gobo.
1. Go to the
LED Frequency
main level.
2. Select PWM Frequency (
25Hz
,
600Hz
,
1200Hz
,
2000Hz
,
4000Hz
, or
6000Hz
).
Back Light
This setting allows for selection of the amount of time the backlight on the WELL Gobo’s display stays on
after the last button is pressed on the control panel.
1. Go to the
Back Light
main level.
2. Select
10S
(10 seconds),
30S
(30 seconds),
2Min
(2 minutes), or
Always
On
(remains on).
Control Panel Lock
This setting locks or unlock the display control panel.
1. Go to the
Key Lock
main level.
2. Select
On
(locks control panel) or
Off
(control panel stays unlocked).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product’s UID.
1. Go to the
Information
main level.
2. Select
Fixture Hours
or
Version
.
Factory Reset
This option restores the WELL Gobo to factory default settings.
1. Go to the
Reset Factory
main level.
2. Select
No
or
Yes
.
The auto programs cannot be edited.
Off
: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3
: The output follows the dimmer value based on the corresponding dimmer
curve, DIM1 being the fastest.
When the control panel lock is activated, the product will prompt for the passcode
to access the menu. Enter the passcode by pressing:
<UP>
,
<DOWN>
,
<UP>
,
<DOWN>
,
<ENTER>
Summary of Contents for WELL GOBO
Page 1: ...USER MANUAL ...