Operation
-16-
Rogue R2X Spot User Manual Rev. 2
Address
This programming level sets the DMX starting address.
•
Starting from the Main Level screen, select
Address,
press
<ENTER>
.
Set the
DMX Address
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison. This option
sets the products DMX address.
•
Change the starting address
(001–512)
, press
<ENTER>
.
Run Mode
This programming level sets the DMX personality and controls the different test modes.
•
Starting from the Main Level screen, select
Run Mode,
press
<ENTER>
.
DMX Personality
This option selects which DMX Personality the product uses.
1. Highlight
DMX
, press
<ENTER>
.
2. Select the DMX personality
18CH
or
21CH
, press
<ENTER>
.
•
section for the highest starting address you can select for
each personality.
•
Make sure that the starting addresses on the various products do not overlap
due to the new personality setting.
Auto Test
This option runs every attribute individually through 1 cycle.
•
Highlight
Auto Test
, press
<ENTER>
.
The Auto Test will end after 1 full cycle. You can stop the test by pressing <MENU>
at any time.
Manual Test
This option allows you to run each attribute individually or as a group.
1. Highlight
Manual Test
, press
<ENTER>
.
2. Highlight the desired attribute listed on the control panel screen, press
<ENTER>
.
•
Set the attribute value (
000–255
), press
<ENTER>
.
3. Repeat step 2 for the other attributes.
When exiting the Manual Test level, the values of all tested channels will go back
to zero.
