Page 8 of 17
Orb™ User Manual (Rev. 01a)
4.
O
PERATION
Control Panel Operation
Configuration (DMX)
Set this product in DMX mode to control it with a DMX controller.
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Connect a DMX cable from the DMX output of the DMX controller to the DMX
input socket of this product.
Starting Address
When selecting a starting DMX address, always consider the number of DMX
channels the selected DMX mode uses. If you choose a starting address that is too
high, you could restrict the access to some of the
fixture’s channels.
The
Orb™ uses one DMX channel in DMX mode, which defines the highest
configurable address to 511.
If you are not familiar with the DMX protocol, you may refer to the “DMX Primer”
section in the
“Technical Information”
chapter.
To select the starting address, do the following:
1) Set DIP [10] to the ON position..
2) Using DIP switches [1~9], select the starting address.
If you are not familiar with the procedure to configuring DIP switches, please
refer to the DMX Primer section in the Technical Information chapter of this
manual or visit
http://www.chauvetlighting.com/chauvet-dip-switch-calculator/
.
Summary of Contents for ORB
Page 1: ...User Manual ...