EN
8
MinLasers RGX 2.0, FX 2.0, RBX User Manual
3.
S
ETUP
AC Power
This product includes an external power supply which is auto-ranging and runs on
100~240 VAC, 50/60 Hz power. Only use the included power supply! To obtain a
replacement power supply, contact Chauvet®. To determine the power requirements for a
particular product, see the label affixed to the back plate of the product or refer to the
product’s specifications chart. A product’s listed current rating indicates its average
current draw under normal conditions.
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only
as a 0 to 100% switch.
Mounting
Orientation
The MiN™ Laser FX 2.0/RGX 2.0/RBX
may be mounted in any position
provided there is adequate room for ventilation.
Rigging
Be sure that the structure can support the weight of the product. Please see
the “Technical Specifications” section of this manual for a detailed weight
listing. Mount the product securely. Do this with a screw, nut and bolt, or a
hanging clamp. When rigging, consider routine maintenance. Please see the
following notes on installation.
•
When aiming the products, you may use the bracket adjustment
knob(s). Loosen the knob(s), adjust to the desired angle, and then
tighten the knob(s) by turning clockwise. Do not use tools for this
step, as it may cause damage.
•
Use the floor stand to support the product in a sitting position.
Proper Usage
This product is for overhead mounting only. For safety purposes, CHAUVET®
recommends mounting your lighting effect products on steady elevated platforms or
sturdy overhead supports using suitable hanging clamps. In all cases, you must use
safety cables. You can obtain appropriate mounting hardware from your lighting
vendor. International laser safety regulations require that laser products must be
operated in the fashion illustrated below, with a minimum of 3 meters (9.8 ft) of
vertical separation between the floor and the lowest laser light vertically. Additionally,
3 meters of horizontal separation is required between laser light and audience or
other public spaces.
Bracket Adjustment
Knob
Mounting Bracket
Floor Stand,
Flexible Feet (3)
CAUTION – USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE
OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT
IN HAZARDOUS RADIATION EXPOSURE
