Page 6 of 18
COLORband PiX™ IP User Manual (Rev. 2)
3.
S
ETUP
AC Power
The COLORband PiX™ IP has an auto-ranging power supply and it can work with an
input voltage range of 100–240 VAC, 50/60 Hz.
To determine the product’s power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product’s back panel, or
refer to the product’s specifications chart. The listed current rating indicates the
product’s average current draw under normal conditions.
•
Always connect the product to a GFI protected circuit (circuit breaker or fuse).
Make sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
•
To eliminate wear and improve its lifespan, during periods of non-use
completely disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Power Linking
The product provides a power linking option via the pigtails located on the back of the
unit.
You can daisy chain up to 9 units on 120 VAC or up to 17 units on 230 VAC.
If you choose not to use the power linking feature, be sure to use the included screw on
cap to prevent any water from getting into the power cords.
The power linking information above corresponds to the North American version
of the product ONLY! If using the product in other markets, you must consult with
the local Chauvet distributor as power linking connectors and requirements may
differ in your country or region.
Summary of Contents for colorband PiX IP
Page 1: ...User Manual ...
