4.1 CHARGING XBI2 UNIT
1. XBi2 unit must be off
2. Plug charger into household power supply, then plug charge cord into
the charge port of the XBi2
3. LED display on the XBi2 / charger
- XBi2 Unit
BLUE LED will remain on until XBi2 is done charging
- Charger
RED LED- XBi2 is charging
GREEN LED- XBi2 is done charging
4. For a complete charge it will take approximately 3 hours
*** CHARGE XBI2 UNIT BEFORE PERFORMING ANY OPERATIONS ***
**READ THROUGH INSTRUCTIONS COMPLETELY BEFORE ATTEMPTING OPERATIONS**
*** DO NOT ATTEMPT TO OPERATE UNIT WHILE CHARGING ***
*** DAMAGE TO UNIT OR AC CHARGER MAY OCCUR ***
3.2 ALTERNATIVE FULL FACE XBI2 UNIT HEADSET INSTALLATION
1.Attach double sided mounting tape to the back side of the plastic base
plate. Position the plastic base plate at approximately the middle bottom
of the left side of the helmet and apply.
2.Install speakers at stated in step 2 & 5 of the previous instructions.
3.Position and attach the microphone to the middle of the helmet chin bar
directly in front of the mouth. Use the popsicle stick to gently tuck the mi-
crophone wire between the inner liner and the outer shell of the helmet.
4.Slide XBi2 unit onto the plastic base plate and plug the headset into
the headset port. Use the popsicle stick to gently tuck the speaker wires
between the inner liner and the outer shell of the helmet.
4. BASIC UNIT OPERATION
7
xbi2_maual.indd 9
4/15/09 3:40:49 PM
