3. INSTALLATION
1. Attach plastic base plate to metal mounting bracket by aligning tabs “A”
with slots “B” and sliding plastic base plate onto metal mounting bracket.
Insert screw “D” through metal mounting bracket and into threaded hole
“C” and tighten. (Figure 1)
2. Attach the foam covers and sticky backed velcro discs to the speakers.
(Figure 2)
3. Place the helmet upside down on a soft surface. The metal mounting
bracket should be placed at approximately the middle of the left side of
the helmet. Insert the inner metal portion of the metal mounting bracket
between the inside of the outer shell and the inner liner of the helmet,
slide the metal mounting bracket all the way in while holding the outer
portion away from the helmet. (Figure 3)
Slot “B”
Slot “B”
Tab “A”
Tab “A”
Screw “D”
Threaded hole “C”
Figure 1
Figure 2
Figure
3.1 GENERL INSTALLATION
4. Slide rubber pad between outer shell of helmet and the outer portion of
the metal mounting bracket.
5. Attach the RIGHT speaker (the long wire) to the inside of the helmet.
Attach the LEFT (the short wire) to the inside of the helmet.
6. Slide XBi2 unit onto the plastic base plate and plug the headset into
the headset port. Use the popsicle stick to gently tuck the speaker wires
between the inner liner and the outer shell of the helmet.
6
xbi2_maual.indd 8
4/15/09 3:40:47 PM
