Chatillon DFE I, User Manual

Page: 11 / 85

10
DF II Series User Manual
KEYPAD OPERATION
The DF II Series gauge has nine (9) keys and a
navigation pod.
Function Keys
There are three (3) function keys located immediately
below the gauge display. These keys are mapped to
the display prompt above it. Key functions change
based on the gauge’s current status or operating
mode. If no prompt appears above the key, the key
is inactive.
Navigation Pod
The navigation pod is primarily used during setup.
This circular pod contains four (4) directional arrows
that correspond to certain gauge functions. The UP
and RIGHT arrows are used to increment numbers
or to navigate in an upward direction or to the right.
The DOWN and LEFT arrows are used to decrement
numbers or to navigate in a downward direction or
to the left.
UNITS Key
A dedicated UNITS key is used to change the units
of measure.
ZERO Key
A dedicated ZERO key is used to zero a measured
result or to tare the weight of attachments and
fixtures prior to measuring a load.
HOME Key
A dedicated HOME key is used to return you to the
main operating display.
ENTER Key
A dedicated ENTER key is used to enable a
selection or to accept a result.
Power Key
A dedicated POWER key is used to turn gauge
power ON or OFF.
INFO Key
The INFO key provides you with “information” about
your DF II Series force gauge. It is also used to
review SAVED information that is stored in the gauge
memory.
Depress the “i” key to access the following information:
n
Gauge Capacity x Resolution
n
Firmware Revision and Revision Date
n
Overload History
n
Battery Life
n
Saved Results and Graph of Results
Units
Home
Zero
Enter
i
l



