Chatillon DFE I, User Manual

Page: 59 / 85

58
DF II Series User Manual
bREAK DETECTION SETUP
To setup the Break Detection function, from the
Home display depress F3 (More) three times. Use
the navigation key to position the arrow at the
“Break Detect” function. Press ENTER.
bREAK DETECT - SElECT TYPE
The DFS II break detect default type is Percentage
Break. To change the break detect type to Sharp
Break, select the F1 (Sharp) key.
To change from Sharp Break to Percentage Break,
select F1 (% Drop).
Results are expressed with the following mode
lables:
n STBk (Sharp Break Tension)
n SCBK (Sharp Break Compression)
n %TBK (% Break Tension)
n %CBK (% Break Compression)
SElECTING INCREMENTS
Increments are associated with the numeric values
displayed by the gauge during setup. You select
the increment you want to use to adjust your setup
values. Increments are provided in values
corresponding to the gauge capacity and units of
measure. Increment values available are:
n 0.001
n 0.01
n 0.1
n 1.0
n 10.0
n
100.0
Selecting an increment of 10.0 will adjust the setup
numeric value by “tens”. Selecting the increment
0.1 will adjust the setup numeric value by “tenths”.
You select increments using the RIGHT and LEFT
arrow keys on the navigation pod. Selecting the
RIGHT arrow increases the increment value.
Selecting the LEFT arrow decreases the increment
value.