8
General
Switch off machine after use and remove chips and dust from blades.
Cleaning and maintenance
Always disconnect machine from mains before performing maintenance!
Servicing and replacing blades
Remove side guide and blade guard. Slacken screws (d) with the screwdriver supplied.
Turn blade housing until holder (e) and blade (f) can be removed.
Clean mounting bearings, blade housing and blade with an oily cloth. Replace or sharpen blade if
blunted.
Fit blade and holder in blade housing.
Place blade adjustment gauge (g) on rear table and check blade height is even both ends.
Tighten screws with screwdriver.
Check blade can revolve freely.
Fit guide fence and cover blade housing with blade guard.
