Charnwood W020, Owner'S Manual

Page: 11 / 20

Offer the router up to the underside of the table
with the shaft passing through the cutter
aperture.
Holding the router in position, place the centring
disc over the threaded shaft and then use the
thumb screw to secure it.
Ensuring that the centring disc is correctly
seated in the aperture, release the router plunge
lock and the router will then be held in place
against the underside of the table.
Lock the plunge mechanism again.
Rotate the router body to the most convenient
position for access to the depth and speed
controls. It might subsequently be necessary to
adjust this position slightly to allow the four
clamps to be positioned on convenient parts of
the baseplate.
Base + 13mm
Adjust the rear bolt and locknut on each of the
four mounting clamps as shown.
The distance shown should be equal to the
thickness of your router base plus 13mm.
Mounting Clamp
Add the clamp lock, locking nut, washer and bolt
as shown.
Bolt
Washer
Locking nut
Clamp Lock