Attach the rear extension table to the main
table. Use four M6 x 12mm bolt with spring
washer and standard washer.
Take the two strengthening bars, place them
inside the extension table and insert the bolts
into the end of the bar, next to the rounded side
of the table.
Then attach the rear extension table to the main
table by passing a bolt through the edge of the
main table into the end of the strengthening
bars.
Use a straight edge to check the rear extension
is level with the main table and then fully tighten
the bolts.
Attach the Front Rail
Slide the heads of six M6 x 16mm bolts into the
T-shaped slot in the front rail.
Slide the bolts until they align with the six holes
in the front edge of the table.
Attach the rail using a washer, spring washer
and nut onto each bolt.
Attach The Push Stick Clips
Locate the small holes in the right hand side of
the saw body.
Use the four screws provided to attach the two
spring clips.
Spring Clips
The push stick can be stored in these when not
in use.
Assemble the Riving Knife
Undo the eight screws holding the table insert
and remove the plate.
